How to restart my CubicSecure

Edited

⚠️ Please note that performing a factory reset will erase all applied firmware updates and settings such as hot/cold pairings.

Unplug the power supply

Unplug the micro-USB power cable from the CubicSecure.

Insert a thin pin in the reset hole

Insert a paper clip into the hole on the reset button while plugging in the power cable.

  • Keep holding the reset button for 3 seconds.

Once plugged in, the lights should turn white and stay illuminated during the reset.

Wait until the the reset is complete

Wait for about 3 minutes for the device to start up again.

The STATUS LED might blink white during a couple of seconds or you might hear a beep once the reset is complete.

Was this article helpful?

Sorry about that! Care to tell us more?

Thanks for the feedback!

There was an issue submitting your feedback
Please check your connection and try again.